From FedoraProject

Jump to: navigation, search
A Trimslice proudly wearing a Powered by Fedora case badge.



The Trimslice is one of the most powerful ARM devices available.

Technical Specifications

  • 1 GHz NVIDA Tegra 2 (dual-core ARM Cortex A9)
  • 1 GB DDR2-667 RAM
  • HDMI 1080P capable
  • Gigabit Ethernet (Realtek RTL8111DL)
  • 802.11n Wireless connectivity

For more information on the Trimslice visit their website.

Running Fedora on a Trimslice

This page will give you detailed instructions for running Fedora 17 GA on your Trimslice. There are two images to choose from on the Trimslice, choose the appropriate image for your target media - SD card or SATA/USB drive.

Download the image

The first step is to download the Fedora 17 image. The prebuilt images include kernels and can be written directly to SD Card, USB, or SATA drive and booted without any additional steps or configuration. Both images require a minimum of 2GB and boot to a serial console.

Writing the Image

Linux Users

You can write the image to media of your choosing but it does have to meet the minimum size requirement of 2GB. Connect the media to your computer and make note of the drive. To write the image to your media run the following command, changing the drive to the location of your media.

For the SD Image:

xzcat Fedora-17-armhfp-trimslice-mmcblk0.img.xz> /dev/<location-of-your-media>

For the SATA/USB Image:

xzcat Fedora-17-armhfp-trimslice-sda.img.xz > /dev/<location-of-your-media>

Once completed run the below command to ensure the entire image is written to the device:


Windows Users

  • You will need to download Win32 Image Writer as well as a tool to extract the image such as 7-Zip.
  • Once downloaded and installed right click on the disk image and select "7-Zip->Extract files here"
  • Launch Win 32 Disk Imager and select the extracted disk image and the device you would like to write the files to. Click "Write". Be very careful during this step - all data on the selected drive will be lost!

Using Fedora on the Trimslice

Connect the newly created media to your Trimslice and power on. No further steps are required and your system should boot to a serial console log in prompt. If you do not have a serial cable to connect your Trimslice, you can watch you DHCP server for the newly connected device. After a few minutes you should be able to see the host "fedora-arm'. Use SSH to connect to the root account.

ssh root@fedora-arm (or IP)

The default root password is "fedoraarm". This should be changed immediately.

Additional Support

There are Fedora ARM users all around the globe - if you need assistance, would like to provide feedback or contribute to Fedora ARM please visit us on the IRC - we can be found in #fedora-arm on Freenode. You can also contact us on the mailing list -