QA:Testcase Anaconda User Interface serial console

From FedoraProject

(Difference between revisions)
Jump to: navigation, search
(Updated initctl command)
(remove pre-fedora 9 instructions)
Line 11: Line 11:
 
# The installation displays properly works over the serial line
 
# The installation displays properly works over the serial line
 
# Confirm that a login console is presented over the serial device
 
# Confirm that a login console is presented over the serial device
# When using ''upstart'' (Fedora9), you may confirm that the serial device is configured for login by examining the output of {{command|initctl status serial DEV{{=}}ttyS0}}.  For example,  
+
# When using ''upstart'' (Fedora 9 and later), you may confirm that the serial device is configured for login by examining the output of {{command|initctl status serial DEV{{=}}ttyS0}}.  For example,  
 
#: <pre>serial (ttyS0) start/running, process 1210</pre>
 
#: <pre>serial (ttyS0) start/running, process 1210</pre>
# When using ''sysvinit'' (prior to Fedora9), you may confirm that the file ''/etc/inittab'' has a login entry for the requested serial port.  For example: <pre>co:2345:respawn:/sbin/agetty ttyS1 115200 vt100-nav</pre>
 
 
# The file ''/etc/securetty'' contains a line matching the requested console
 
# The file ''/etc/securetty'' contains a line matching the requested console
 
}}
 
}}
 
[[Category:User Interface]]
 
[[Category:User Interface]]

Revision as of 19:36, 23 October 2010

Description

This test is intended to ensure that the console= parameter is honored and the post-installed systems is configured properly for a non tty0 console. While the examples mention the use of console=ttyS0, it it acceptable to use any device other than the default tty0.

Note.png
Serial Cable?
This test case may require using a DB-9 serial cable to connect to the system under test. Additionally, you may be required to update the BIOS to enable the serial port.
Idea.png
Go Virtual
Since the focus of this test is not to validate the physical DB-9 serial cable connection, or to ensure the cables are seated properly, it is entirely acceptable (and encouraged) to use Virtualization. For example, creating any KVM/QEMU virtual guest with the correct console=ttyS0 serial will setup a serial console for use with this test.


How to test

  1. Using a DB-9 serial cable, connect to your test system on the first port (typically S0) and start a serial port monitoring application (ttywatch, cermit, or minicom)
  2. Boot installation program passing the console=ttyS0 command line parameter
  3. Complete installation and boot into installed system

Expected Results

  1. The installation displays properly works over the serial line
  2. Confirm that a login console is presented over the serial device
  3. When using upstart (Fedora 9 and later), you may confirm that the serial device is configured for login by examining the output of initctl status serial DEV=ttyS0. For example,
    serial (ttyS0) start/running, process 1210
  4. The file /etc/securetty contains a line matching the requested console