From Fedora Project Wiki
(Created page with '{{header|infra}} {{shortcut|ISOP:mismatch_cnt}} What to do when a raid device has a mismatch count == Contact Information == Owner: Fedora Infrastructure Team Contact: #fedora...')
 
m (Change from .txt to .rst)
 
(4 intermediate revisions by 3 users not shown)
Line 2: Line 2:
{{shortcut|ISOP:mismatch_cnt}}
{{shortcut|ISOP:mismatch_cnt}}


What to do when a raid device has a mismatch count
{{admon/important|This SOP has moved to the fedora Infrastructure SOP git repo. Please see the current document at: [http://infrastructure.fedoraproject.org/infra/docs/infra-raidmismatch.rst mismatch]
 
For changes, questions or comments, please contact anyone in the Fedora Infrastructure team. }}
== Contact Information ==
Owner: Fedora Infrastructure Team
 
Contact: #fedora-admin, sysadmin-main
 
Location: All
 
Servers: Physical hosts
 
Purpose: Provides database connection to many of our apps.
 
== Description ==
 
In some situations a raid device may indicate there is a count mismatch as listed in:
 
<pre>
/sys/block/mdX/md/mismatch_cnt
</pre>
 
Anything other than 0 is considered not good.  Though if the number is low it's probably nothing to worry about.  To correct this situation try the directions below
 
== Correction ==
 
More than anything these steps are to A) Verify there is no problem and B) make the error go away. If these steps do not make the mismatch go away then there is likely a problem with one of the disks.  At that point <b>PROCEED WITH CAUTION</b>.  The steps below though should be fairly safe.
 
=== Step 1 ===
 
Issue a repair (replace mdX with the questionable raid device):
 
<pre>
echo repair > /sys/block/mdX/md/sync_action
</pre>
 
Depending on the size of the array and disk speed this can take a while. Watch the progress with:
 
<pre>
cat /proc/mdstat
</pre>
 
Once that's done proceed to Step 2.
 
=== Step 2 ===
 
Issue a check. It's this check that will reset the mismatch count if there are no problems.  Again replace mdX with your actual raid device.
 
<pre>
echo check > /sys/block/mdX/md/sync_action
</pre>
 
Just as before, you can watch the progress with:
 
<pre>
cat /proc/mdstat
</pre>


[[Category:Infrastructure SOPs]]
[[Category:Infrastructure SOPs]]

Latest revision as of 18:31, 20 July 2015

Shortcut:
ISOP:mismatch_cnt
This SOP has moved to the fedora Infrastructure SOP git repo. Please see the current document at: mismatch For changes, questions or comments, please contact anyone in the Fedora Infrastructure team.