From Fedora Project Wiki

No edit summary
No edit summary
Line 1: Line 1:
{{QA/Test_Case
{{QA/Test_Case
|description=This test case tests hibernation via the pm-hibernate command.
|description=This test case tests hibernation via the pm-hibernate command.
{{admon/warning|If you are running from the LiveCD / USB you will need physical swap partition on the host machine in order to run this test case. Swap on LVM / LUKS is currently not supported for the resume when running from the LiveCD / USB.}}
{{admon/warning|If you are running from the LiveCD / USB you will need physical swap partition on the host machine in order to run this test case. Swap on LVM / LUKS is currently not supported when running from the LiveCD / USB.}}
|setup=
|setup=
# Check that you have {{package|pm-utils}} installed:
# Check that you have {{package|pm-utils}} installed:
#:<pre># rpm -q pm-utils</pre>
#:<pre># rpm -q pm-utils</pre>
# Check that the hibernate is supported on your platform:
#:<pre>$ cat /sys/power/state</pre>
#:If there is <pre>disk</pre> in the output, it signals that the hibernate is supported.
# Check your swap:
# Check your swap:
#:<pre>$ free</pre>
#:<pre>$ free</pre>

Revision as of 13:00, 27 September 2011

Description

This test case tests hibernation via the pm-hibernate command.

If you are running from the LiveCD / USB you will need physical swap partition on the host machine in order to run this test case. Swap on LVM / LUKS is currently not supported when running from the LiveCD / USB.

Setup

  1. Check that you have pm-utils installed:
    # rpm -q pm-utils
  2. Check that the hibernate is supported on your platform:
    $ cat /sys/power/state
    If there is
    disk
    in the output, it signals that the hibernate is supported.
  3. Check your swap:
    $ free
Your swap size should be at least your RAM size or more, otherwise the hibernate may fail. Even if your swap size is less than your RAM size, you can try this test case, but please signal this in your report, especially in case of failure.
    • Your swap size should be at least twice your RAM size.

How to test

  1. Run the following command:
    # pm-hibernate
  2. Wait for hibernation process to complete (it can take cca. 5-60 seconds).
  3. Resume by hitting the power button.

Expected Results

  1. System correctly hibernates.
  2. System correctly resumes.