From Fedora Project Wiki

Revision as of 19:40, 22 April 2011 by Devos (talk | contribs) (→‎How To: Use the Fedora 13 rootfs on a Pogoplug: Mention the Pogoplug variant)

This page is a draft only
It is still under construction and content may change. Do not rely on the information on this page.
This page is based on the howto for Fedora 12 on a BeagleBoard-xM

How To: Use the Fedora 13 rootfs on a Pogoplug

The Pogoplug is installed with a very minimal (busybox) imate on the 3rd MTD-partition. In order to boot a full distribution from a USB-stick or disk, like Fedora, it is needed to replace the bootloader (u-boot) to make it USB-aware. Changing the bootloader will probably make the Pogoplug unsupported by the vendor. This guide describes how to install Fedora on the pink Pogoplug V2.

What you need

To complete this guide, you'll need

  • Internet access on the Pogoplug
  • An external USB-stick or disk

Replace u-boot to be able to boot from USB-storage

  1. register the Pogoplug
  2. enable SSH access
  3. update the bootloader

Preparation of the USB-stick or disk

Create a partition on the USB-storage. Note that it should be a primary partition with number 1 (like /dev/sdX1).

Label the partition rootfs, and format it as ext3:

mkfs -t ext3 -L rootfs /dev/sdX1
tune2fs -c 0 -i 0 /dev/sdX1

Mount the partition:

mount /dev/sdX1 /mnt

Copy rootfs to USB-storage

Now that the rootfs partition has been created, it's time to extract the Fedora 13 root filesystem onto it. First, download the prebuilt root file system. Once it's downloaded, navigate to the rootfs partition in a terminal, and extract the rootfs using the following commands:

su -c 'tar xjvf /path/to/rootfs-f13-beta-2011-03-23.tar.bz2 ./'

Replace /path/to/rootfs-f13-beta-2011-03-23.tar.bz2 with the path to rootfs-f13-beta-2011-03-23.tar.bz2 on your system.

Copy kernel and modules to the USB-storage

A working kernel (2.6.31.1) and modules can be taken are available from the Fedora 13 ARM Beta2 page:

Make the kernel findable by the modified u-boot

su -c 'tar xzvf /path/to/uImage.tgz -C ./boot'

The uImage file should be placed under /boot on the first partition of the USB-storage. This is where u-boot tries to find it.

Make the modules available for loading during runtime

su -c 'tar xzvf /path/to/modules.tgz'

Replace /path/to/modules.tgz with the location of your downloaded modules.tgz file. There is no need to run depmod as the generated files are already part of the archive. All .ko files should be located under the /lib/modules/2.6.36.1 directory on the USB-storage.


Extra settings

This section outlines some of the additional configuration changes that need to be made.

Filesystems

The Fedora 13 root filesystem is set up by default to mount a NFS share as the root partition. This can be corrected by changing /etc/fstab. In the rootfs partition, open the etc/fstab (note there is NO prepending slash) and change the first line to read:

LABEL=rootfs        /           ext3    defaults     0 0

Finished

Unmount the USB-storage on your PC, connect it to the Pogoplug and reboot it.