Architectures/ARM/EFIKA MX Smarttop

From FedoraProject

< Architectures | ARM
Revision as of 03:00, 20 June 2012 by Pwhalen (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
A stack of EFIKA MX Smarttops donated for use by Fedora ARM.

Contents

EFIKA MX Smarttop

The EFIKA MX Smarttop is a network computer based around the EFIKA MX micro-motherboard and requires no more than 5W to fully operate. . At this time there is no support for a display and the Smarttop boots to a serial.

Technical Specifications

  • Freescale i.MX515 (ARM Cortex-A8 800MHz)
  • 512MB RAM
  • HDMI
  • 10/100Mbit/s Ethernet
  • 802.11 b/g/n WiFi

For more information on the EFIKA MX Smarttop visit their website.

Running Fedora on a EFIKA MX Smarttop

This page will give you detailed instructions for running Fedora 17 GA on your EFIKA MX Smarttop. There are two images to choose from on the EFIKA MX Smarttop, choose the appropriate image for your target media - SD card or SATA/USB drive.

Download the image

The first step is to download the Fedora 17 image. The prebuilt images include kernels and can be written directly to SD Card, USB, or SATA drive and booted without any additional steps or configuration. Both images require a minimum of 2GB and boot to a serial console.


Writing the Image

Linux Users

You can write the image to media of your choosing but it does have to meet the minimum size requirement of 2GB. Connect the media to your computer and make note of the drive. To write the image to your media run the following command, changing the drive to the location of your media.

For the SD Image:

Fedora-17-armhfp-mx51-mmcblk0.img.xz> /dev/<location-of-your-media>

Once completed run the below command to ensure the entire image is written to the device:

sync

Windows Users

  • You will need to download Win32 Image Writer as well as a tool to extract the image such as 7-Zip.
  • Once downloaded and installed right click on the disk image and select "7-Zip->Extract files here"
  • Launch Win 32 Disk Imager and select the extracted disk image and the device you would like to write the files to. Click "Write". Be very careful during this step - all data on the selected drive will be lost!

Using Fedora on the EFIKA MX Smarttop

Connect the newly created media to your EFIKA MX Smarttop and power on. No further steps are required and your system should boot to a serial console log in prompt. If you do not have a serial cable to connect your Smarttop, you can watch your DHCP server for the newly connected device. After a few minutes you should be able to see the host "fedora-arm'. Use SSH to connect to the root account.

ssh root@fedora-arm (or IP)

The default root password is "fedoraarm". This should be changed immediately.

Additional Support

There are Fedora ARM users all around the globe - if you need assistance, would like to provide feedback or contribute to Fedora ARM please visit us on the IRC - we can be found in #fedora-arm on Freenode. You can also contact us on the mailing list - arm@lists.fedoraproject.org