From Fedora Project Wiki
(Comments and Discussion)
Line 77: Line 77:
<!-- When your feature page is completed and ready for review -->
<!-- When your feature page is completed and ready for review -->
<!-- remove Category:FeaturePageIncomplete and change it to Category:FeatureReadyForWrangler -->
<!-- remove Category:FeaturePageIncomplete and change it to Category:FeatureReadyForWrangler -->

Revision as of 17:44, 23 July 2009

Clustered Samba for GFS2


Support for clustered samba (including active/active configuration) over GFS2 using CTDB.


Current status

  • Targeted release: Fedora 12
  • Last updated: 7/20/2009
  • Percentage of completion: 30%

Detailed Description

With the availability of a clustered database (CTDB) for Samba, multiple instances of smbd across different nodes of a cluster are able to share state. It is now possible to export a gfs2 filesystem through one or more nodes in the cluster in a active/passive or active/active configuration to provide a highly-available Samba service.

Benefit to Fedora

Samba was not cluster-aware until the introduction of CTDB and hence it was not possible to have a highly available samba service. Particularly, active/active configuration was not possible. With this feature, it will be possible to run highly available samba service(s) with different configurations (active/active, active/passive) over a shared gfs2 filesystem on the Red Hat cluster infrastructure.


  • Verify simple functionality by exporting samba shares over gfs2 and running smbtorture tests (in progress)
  • fcntl posix locks performance: Improve upon gfs2's posix lock performance (single-node & clustered) as smbd uses them extensively when posix locking is turned on. (in progress)
  • Get CTDB and CTDB-supported Samba packages into F12. (complete)
  • Get Conga interface ready for manipulating the various config files (/etc/cluster/cluster.conf, /etc/sysconfig/ctdb, /etc/samba/smb.conf) through web-based GUI. (Alternative to hand-editing configs) (in progress)
  • Verify working of clustered samba use cases such as service failover, recovery, etc., and document respective configuration parameters. (in progress)

This feature will not affect the operation of non-clustered samba setups or other gfs2-based setups. It will provide the capability to setup clustered samba over gfs2.

How To Test

Hardware Requirements

  • cluster nodes (2 or more) connected to shared storage
  • client node(s) to run client loads from.


  • kernel with gfs2 and dlm enabled
  • Red Hat cluster packages cman/openais/corosync/lvm2-cluster etc. See usage.txt for more information.
  • Latest samba and ctdb packages.


  • Setup the cluster.conf file and start up the cluster 'service cman start'
  • If you're using clustered lvm, 'service clvmd start'
  • mount a gfs2-formatted clustered volume at the same mountpoint on all nodes.
  • Export this mountpoint (or a directory within it) as a samba share. All smb.conf files in all nodes should be identical
  • Set ctdb configuration. See ctdb setup
  • start the ctdb service and check 'ctdb status' to make sure the ctdb cluster is up.
  • Now you should simultaneously be able to access the samba share through all the exporting nodes and run operations on them simultaneously.


  • The smbtorture test suite in the samba package has a few scenarios RAW_BENCH_LOCK, RAW_BENCH_OPEN, BENCH_NBENCH etc. See testing ctdb
  • There's also the ping_pong test at: ping_pong doc
  • Any other test you can think of with multiple clients (windows users mounting the samba share) that stresses ctdb/gfs2.

User Experience

Users not using gfs2, samba or ctdb should notice no change. Users will now have the ability to run a clustered samba setup exporting gfs2 shares.


Most of the kernel support (gfs2 filesystem) is already upstream. ctdb and samba packages have been included in Fedora.

Contingency Plan

In it's current state, a basic clustered samba setup should work. Enhancements such as posix lock performance & conga interface and testing of different use-cases would be nice to get done with. If not done with these tasks, in it's current form, the feature is still acceptable.


Release Notes

  • Fedora now has support for clustered samba over gfs2

Comments and Discussion