From Fedora Project Wiki

(Fix admin)
Line 28: Line 28:
# System should boot and start anaconda loader without error
# System should boot and start anaconda loader without error
# System can transition to stage#2 anaconda
# System can transition to [ stage2] anaconda
[[Category:Installer Boot Methods]]
[[Category:Installer Boot Methods]]

Revision as of 06:12, 18 December 2009


IBM PowerPC products do not have a BIOS as typical intel-based architectures do. Instead, they offer Open Firmware. Open Firmware provides an interactive shell where you can configure the boot process.

From wikipedia:OpenFirmware ..

 Open Firmware (also, 'OpenBoot') is a hardware-independent firmware (computer
 software which loads the operating system), developed by Sun Microsystems, and
 used in post-NuBus PowerPC-based Apple Macintosh computers, Sun Microsystems
 SPARC based workstations and servers, IBM POWER systems, and PegasosPPC
 systems, among others. On those computers, Open Firmware fulfills the same
 tasks as BIOS does on PC computers.

 It is accessed by a user by a Forth-based shell interface. Forth is a powerful
 high level language. For example, it is possible to program Open Firmware to
 solve the Tower of Hanoi problem.[1] 

 It was going to be described by IEEE standard IEEE-1275, which was not
 reaffirmed by the OFWG and has been officially withdrawn by IEEE.
 Unfortunately, this means it is unavailable from the IEEE.
tftp required
This test will require access to a tftp server on the same network as the system under test. For information on installing and configuring a tftpserver, consult the installation guide.

How to test

  1. Boot the system under test into Open Firmare. A key sequence may be required to direct the system to boot Open Firmware.
  2. Locate the file images/netboot/ppc64.img from the installation source. Copy this file into a directory accessible by your tftpserver. For example,
     cp images/netboot/ppc64.img /var/lib/tftpboot/
  3. Direct the system under test to boot this file. For example, from Open Firmware you may issue a command similar to
    boot network:,\ppc64.img
  4. Proceed through installation as desired

Expected Results

  1. System should boot and start anaconda loader without error
  2. System can transition to stage2 anaconda