QA:Testcase biosdevname NIC naming after install

From FedoraProject

(Difference between revisions)
Jump to: navigation, search
Line 20: Line 20:
 
<pre>#[root@fedora-14-r710 ~]# ls /sys/class/net/
 
<pre>#[root@fedora-14-r710 ~]# ls /sys/class/net/
 
lo  pci3#1 pci3#2 pci4#1</pre>
 
lo  pci3#1 pci3#2 pci4#1</pre>
<li> Make sure ifcfg-emN and ifcfg-pci<slot>#<port> files are created after the installation is complete.
+
<li> Make sure ifcfg-emN and ifcfg-pci<slot>#<port> files are created under the dir {{filename|/etc/sysconfig/network-scripts}} after the installation is complete.
 
<pre># cat ifcfg-em3
 
<pre># cat ifcfg-em3
 
# Please read /usr/share/doc/initscripts-*/sysconfig.txt
 
# Please read /usr/share/doc/initscripts-*/sysconfig.txt

Revision as of 13:14, 24 January 2011


Contents

Description

This test case makes sure that during Rawhide installation, network interfaces, both onboard and PCI add-in are named as per the new convention.

Setup

  1. Make sure that the Hardware Requirements are met.

How to test

  1. Switch to a shell by pressing Control+Alt+F2.
  2. Verify that onboard network interfaces are named as described here
  3. Verify that PCI add-in network interfaces are described here
  4. When the network configuration wizard appears, configure em1 and any of the available add-in PCI interface.
  5. Complete the installation process, after the system reboots, login to the system. Check if interface configuration file ifcfg-emN and ifcfg-pci<slot>#<port> files are created under /etc/sysconfig/network-scripts

Expected Results

  1. Make sure that onboard device names are of the form emN during install time
    [root@fedora-14-r710 ~]# ls /sys/class/net/
    em1  em2  em3  em4  lo
  2. Make sure that PCI add-in device names are of the form pci<slot>#<port> during install time
    #[root@fedora-14-r710 ~]# ls /sys/class/net/
    lo  pci3#1 pci3#2 pci4#1
  3. Make sure ifcfg-emN and ifcfg-pci<slot>#<port> files are created under the dir /etc/sysconfig/network-scripts after the installation is complete.
    # cat ifcfg-em3
    # Please read /usr/share/doc/initscripts-*/sysconfig.txt
    # for the documentation of these parameters.
    DEVICE=em3
    BOOTPROTO=dhcp
    TYPE=Ethernet
    HWADDR=00:24:e8:2e:df:03
    ONBOOT=yes
    USERCTL=no
    PEERDNS=yes
    IPV6INIT=no
    
    # cat ifcfg-pci3#1
    # Please read /usr/share/doc/initscripts-*/sysconfig.txt
    # for the documentation of these parameters.
    DEVICE='pci3#1'
    BOOTPROTO=dhcp
    TYPE=Ethernet
    HWADDR=00:1b:21:44:63:40
    ONBOOT=yes
    USERCTL=no
    PEERDNS=yes
    IPV6INIT=no