QA:Testcase biosdevname NIC naming after install

Description

This test case makes sure that during Rawhide installation, network interfaces, both onboard and PCI add-in are named as per the new convention.

Setup

1. Make sure that the Hardware Requirements are met.

How to test

1. Switch to a shell by pressing Control+Alt+F2.
2. Verify that onboard network interfaces are named as described here - Verify that onboard interfaces are named as emN
3. Verify that PCI add-in network interfaces are described here - Verify that PCI add-in interfaces are named as pci<slot>#<port>
4. When the network configuration wizard appears, configure em1 and any of the available add-in PCI interface.
5. Complete the installation process, after the system reboots, login to the system. Check if interface configuration file ifcfg-emN and ifcfg-pci<slot>#<port> files are created under /etc/sysconfig/network-scripts

Expected Results

1. Make sure that onboard device names are of the form emN during install time

   # ls ifcfg-em1
   ifcfg-em1

2. Make sure that PCI add-in device names are of the form pci<slot>#<port> during install time

   # ls ifcfg-pci3#2_0
   ifcfg-pci3#2_0

3. Make sure ifcfg-emN and ifcfg-pci<slot>#<port> files are created after the installation is complete.

   # cat ifcfg-em3
   # Please read /usr/share/doc/initscripts-*/sysconfig.txt
   # for the documentation of these parameters.
   DEVICE=em3
   BOOTPROTO=dhcp
   TYPE=Ethernet
   HWADDR=00:24:e8:2e:df:03
   ONBOOT=yes
   USERCTL=no
   PEERDNS=yes
   IPV6INIT=no
   
   # cat ifcfg-pci3#1
   # Please read /usr/share/doc/initscripts-*/sysconfig.txt
   # for the documentation of these parameters.
   DEVICE='pci3#1'
   BOOTPROTO=dhcp
   TYPE=Ethernet
   HWADDR=00:1b:21:44:63:40
   ONBOOT=yes
   USERCTL=no
   PEERDNS=yes
   IPV6INIT=no