QA:Testcase biosdevname interface configuration

From FedoraProject

(Difference between revisions)
Jump to: navigation, search
(Use test case template and add to biosdevname category)
Line 1: Line 1:
== Description ==
+
{{QA/Test_Case
This test case verifies that you can configure the network interfaces with the new naming scheme.
+
|description=This test case verifies that you can configure the network interfaces with the new naming scheme.
 +
|setup=
 +
# Boot into a {{FedoraVersion|long|next}} or [[Releases/Rawhide|Rawhide]] kernel.
 +
|actions=
 +
# Run the command {{command|system-config-network}} to configure and enable an on-board device such as <code>em1</code>
 +
# Run the command {{command|system-config-network}} to configure and enable an add-in network device such as <code>pci3#1</code>
 +
# Run the command {{command|system-config-network}} to configure and enable a SRIOV virtual function network device such as <code>pci3#1_0</code>
 +
|results=
 +
# All attempts to run {{command|system-config-network}} succeed and enable the desired device as expected.  This can be confirmed using the command {{command|ifconfig}} and inspecting the interface configuration files in {{filename|/etc/sysconfig/network-scripts/ifcfg-*}}
 +
# All configured network interfaces are able to pass traffic.
 +
}}
  
== Setup ==
+
[[Category:Package biosdevname test cases]]
Boot into the Rawhide kernel.
+
 
+
== Howto Test ==
+
 
+
#Execute 'system-config-network' and configure (set IP address) em1.
+
#Execute 'system-config-network' and configure (set IP address) pci3#1
+
#Execute 'system-config-network' and configure (set IP address) pci3#1_0
+
 
+
== Expected Results ==
+
#Make sure steps 1, 2 and 3 of 'How to Test' succeed.
+
#Make sure each of the network interfaces can pass traffic.
+

Revision as of 19:46, 19 January 2011

Contents

Description

This test case verifies that you can configure the network interfaces with the new naming scheme.

Setup

  1. Boot into a Fedora 21 or Rawhide kernel.

How to test

  1. Run the command system-config-network to configure and enable an on-board device such as em1
  2. Run the command system-config-network to configure and enable an add-in network device such as pci3#1
  3. Run the command system-config-network to configure and enable a SRIOV virtual function network device such as pci3#1_0

Expected Results

  1. All attempts to run system-config-network succeed and enable the desired device as expected. This can be confirmed using the command ifconfig and inspecting the interface configuration files in /etc/sysconfig/network-scripts/ifcfg-*
  2. All configured network interfaces are able to pass traffic.