QA:Testcase install to iSCSI no authentication
This install verifies that unauthenticated access to and installation with an iSCSI  block device works properly. While this test can be performed on systems with iBFT  support, it is intended for systems that do not support booting iSCSI volumes. For a more exhaustive test iSCSI strategy, refer to QA:iSCSI_Installation_Test_plan.
If a hardware iSCSI target is unavailable, you may setup a software iSCSI target following the instructions at Scsi-target-utils_Quickstart_Guide#Up_and_running_in_3_steps.
How to test
- Start installation using any available means (CD, DVD,
- Advance to the installer hub
- Click on Installation Destination
- Under "Specialized & Network Disks" click on "Add a disk..."
- Click on "Add iSCSI Target..."
- Fill out the Target IP address and click on "Start Discovery"
- Select the correct node in the list of discovered targets
- Select "No Authentication (discovery authentication disabled)" as the Node login authentication type
- Click the "log in" button (not the "OK" button)
- Select the desired virtual disk by using the checkbox on the left hand side of the spoke
- Click "Done"
- At this point, there should be checkmark icons on the iSCSI virtual disk and the local disk needed for boot
- Enter the custom partitioning screen
- Make sure that /boot is on the local disk and '/' is on the iSCSI virtual disk
- Complete installation as desired.
- The installer connects to the iSCSI target without error
- All expected iSCSI disks are included in list of available disks.
- Installation completes without error.
- The installed system boots with all filesystems on the iSCSI device mounted. For assistance troubleshooting network boot issues, consult How_to_debug_Dracut_problems.