From Fedora Project Wiki
m (update for rebase to f29)
m (link for manual partitioning selection)
Line 4: Line 4:
 
# Download the Fedora 28 Silverblue image [https://download.fedoraproject.org/pub/fedora/linux/releases/28/AtomicWorkstation/x86_64/iso/Fedora-AtomicWorkstation-ostree-x86_64-28-1.1.iso here]
 
# Download the Fedora 28 Silverblue image [https://download.fedoraproject.org/pub/fedora/linux/releases/28/AtomicWorkstation/x86_64/iso/Fedora-AtomicWorkstation-ostree-x86_64-28-1.1.iso here]
 
# Boot the iso in VM or Baremetal
 
# Boot the iso in VM or Baremetal
# Install Fedora 28 Silverblue by making sensible choices using anaconda
+
# Install Fedora 28 Silverblue by making sensible choices using anaconda. If you are opting for manual partitioning, follow the instruction from [https://docs.fedoraproject.org/en-US/fedora-silverblue/installation-guide/#manual-partition here]
 
# Finish the initial setup
 
# Finish the initial setup
 
|actions=
 
|actions=

Revision as of 13:54, 19 September 2018

Description

This test case will focus on upgrading the rpm-ostree in Silverblue

Setup

  1. Download the Fedora 28 Silverblue image here
  2. Boot the iso in VM or Baremetal
  3. Install Fedora 28 Silverblue by making sensible choices using anaconda. If you are opting for manual partitioning, follow the instruction from here
  4. Finish the initial setup

How to test

  1. Update gpgkeypath in file /etc/ostree/remotes.d/fedora-workstation.conf from gpgkeypath=/etc/pki/rpm-gpg/RPM-GPG-KEY-fedora-28-primary to gpgkeypath=/etc/pki/rpm-gpg/RPM-GPG-KEY-fedora-29-primary
  2. Run sudo rpm-ostree rebase fedora/29/x86_64/silverblue to perform rebase
  3. Issue systemctl reboot

Expected Results

  1. Step #1 completes without error
  2. The system should reboot
  3. Everything should work fine after reboot