From Fedora Project Wiki
No edit summary
mNo edit summary
(19 intermediate revisions by 2 users not shown)
Line 2: Line 2:
|description=This test case ensures that disk drive(s) are properly unmounted during a power-down or a restart.
|description=This test case ensures that disk drive(s) are properly unmounted during a power-down or a restart.
|setup=
|setup=
# Install the pre-released version of Fedora to be tested on a bare metal system.
# Install the pre-released version of Fedora to be tested. If you are installing from a LiveOS, perform the steps below with the LiveOS before doing the install. After this go ahead with the install. Then perform the steps below when the system is running from the hard drive.
# Reboot the system to the hard drive after the install.
# Reboot the system to the hard drive after the install.
{{admon/warning| Be sure to use a Bare Metal system.}}
 
|actions=
|actions=
# On the running system, Switch to a free virtual console using Ctrl+Alt+F<n> shortcut and log in.
# On the running system, Switch to a free virtual console using Ctrl+Alt+F<n> shortcut and log in.
# At the command prompt, issue the following command {{command|journalctl -b /usr/lib/systemd/systemd-fsck}}
# At the command prompt, issue the following command: <pre>journalctl -b | grep -E "dirty bit|data may be corrupt|recovery|unmounted|recovering"</pre> There should not be any output.
# Review the journal output. Expected Result 1 below shows an example of a good result. Result 2 below shows an example of a bad result. In the bad result note "Clearing orphaned inode", "Dirty bit is set", "not properly unmounted", and "not properly unmounted". These are example failure indicators.
# If there has been output from the grep command, issue the following command {{command| journalctl -b -l > journal.log}} Please file a bug report and attach the journal.log file to the bug report.
# Close the Journal output and power off the system using the command {{command|poweroff}}on the virtual console.
# Restart the test system using the command {{command|reboot}} on the virtual console.
# After a short wait (15 or 20 seconds) power on your test system with the power button. When the system is running, repeat steps 1 through 3 above.
# Repeat steps 1 and 3 above.
# Close the Journal output and restart the test system using the command {{command|reboot}} on the virtual console.
 
# Repeat steps 1 through 3 above.
|results=
|results=
# Good Result example: -- Logs begin at Mon 2019-08-19 22:09:28 EDT, end at Wed 2019-11-27 19:00:08 EST.
# The greps should not produce any output.
 
Nov 27 07:28:10 localhost.localdomain systemd-fsck[570]: /dev/mapper/fedora_localhost--live-root: clean, 270336/4587520 files, 3312639/18350080 blocks
 
Nov 27 07:28:23 localhost.localdomain systemd-fsck[849]: /dev/mapper/fedora_localhost--live-home: clean, 58396/117088256 files, 9028585/468341760 blocks
 
Nov 27 07:28:23 localhost.localdomain systemd-fsck[848]: /dev/sda1: clean, 416/65536 files, 77941/262144 blocks 
 
2. Bad result example: -- Logs begin at Tue 2019-08-27 09:26:40 CEST, end at Tue 2019-11-26 14:50:14 CET. --
Nov 25 10:25:20 phoenix systemd-fsck[684]: root: recovering journal
 
Nov 25 10:25:20 phoenix systemd-fsck[684]: root: Clearing orphaned inode
12325283 (uid=1000, gid=1000, mode=0100644, size=641092)
 
Nov 25 10:25:20 phoenix systemd-fsck[684]: root: Clearing orphaned inode
12331101 (uid=1000, gid=1000, mode=0100644, size=641092)
 
Nov 25 10:25:20 phoenix systemd-fsck[684]: root: clean, 1023215/26869760
files, 46957728/107451392 blocks
 
Nov 25 09:25:22 phoenix systemd-fsck[877]: boot: recovering journal
 
Nov 25 09:25:22 phoenix systemd-fsck[878]: fsck.fat 4.1 (2017-01-24)
 
Nov 25 09:25:22 phoenix systemd-fsck[878]: 0x25: Dirty bit is set. Fs was
not properly unmounted and some data may be corrupt
 
Nov 25 09:25:22 phoenix systemd-fsck[878]:  Automatically removing dirty
bit.
 
Nov 25 09:25:22 phoenix systemd-fsck[878]: Performing changes.
 
Nov 25 09:25:22 phoenix systemd-fsck[878]: /dev/nvme0n1p1: 34 files,
6897/51145 clusters
 
Nov 25 09:25:22 phoenix systemd-fsck[877]: boot: clean, 103/65536 files,
67833/262144 blocks
 
}}
}}
[[Category:Base_Acceptance_Test_Cases]]
[[Category:Base_Acceptance_Test_Cases]]
[[Category:Package systemd test cases]]
[[Category:Package systemd test cases]]

Revision as of 16:30, 6 January 2020

Description

This test case ensures that disk drive(s) are properly unmounted during a power-down or a restart.

Setup

  1. Install the pre-released version of Fedora to be tested. If you are installing from a LiveOS, perform the steps below with the LiveOS before doing the install. After this go ahead with the install. Then perform the steps below when the system is running from the hard drive.
  2. Reboot the system to the hard drive after the install.

How to test

  1. On the running system, Switch to a free virtual console using Ctrl+Alt+F<n> shortcut and log in.
  2. At the command prompt, issue the following command:
    journalctl -b | grep -E "dirty bit|data may be corrupt|recovery|unmounted|recovering"
    There should not be any output.
  3. If there has been output from the grep command, issue the following command journalctl -b -l > journal.log Please file a bug report and attach the journal.log file to the bug report.
  4. Restart the test system using the command reboot on the virtual console.
  5. Repeat steps 1 and 3 above.

Expected Results

  1. The greps should not produce any output.