From Fedora Project Wiki

Description

Setup required for the OpenStack Volumes. In the Folsom release of OpenStack, the nova-volume service was deprecated by the split out cinder service.


How to test

To create the cinder-volumes Volume Group for the openstack-cinder-volume service

sudo truncate -s20G /var/lib/cinder/cinder-volumes.img
sudo vgcreate cinder-volumes $(sudo losetup --show -f /var/lib/cinder/cinder-volumes.img)


Because the volume service is dependent on the volume group being available, it's not started by default, so to do that:

sudo systemctl start openstack-cinder-volume.service

Actions after each reboot

The above commands are not persistent across reboots, so please rerun these commands after reboot:

sudo losetup -f /var/lib/cinder/cinder-volumes.img
sudo systemctl start openstack-cinder-volume.service

If you intend to make them persist automatically, then enable the service to start in the standard manner, but ensure that the losetup is run early in the boot process, or instead, use an implicitly persistent block device/partition.

Integration with tgtd

In RHEL based systems the config files in /etc/tgt/conf.d/ don't honor globbing. Only the main /etc/tgt/targets.conf seems does. So to avoid that issue causing tgtd to not start:

sudo sed -i '1iinclude /etc/nova/volumes/*' /etc/tgt/targets.conf
sudo sed -i '1iinclude /etc/cinder/volumes/*' /etc/tgt/targets.conf

then restart tgtd:

sudo service tgtd restart

Expected Results

Check the volume group is listed by this command

sudo vgs

Check that no errors are reported in /var/log/cinder/* or by this command:

sudo systemctl status openstack-cinder-volume.service