From Fedora Project Wiki

Revision as of 05:50, 22 November 2012 by Adamwill (talk | contribs) (revise for newUI)


A complete installation using a software RAID device for the root (/) file system. For more details on RAID please consult .


  1. Use a system with multiple disks but no hardware or firmware RAID arrays for testing: a virtual machine with multiple virtual disks is fine

How to test

  1. Boot the installer using any available means
  2. At the Installation Destination screen, be sure that Encrypt my data. I'll set a passphrase later is not selected
  3. Select the appropriate disk, and continue installation
  4. Check the box to enter custom partitioning mode
  5. Create the required boot partitions needed for your architecture as non-RAID partitions. This includes /boot and swap
  6. Create a partition, set its mount point to / and set its type to RAID
  7. Optionally, also create a RAID /home partition
  8. Finish the installation, choosing all provided defaults

Expected Results

  1. The installer should successfully create and install to the RAID devices: unrelated failures should be reported but do not constitute a failure of this test case
  2. After booting the installed system, inspection of /proc/mdstat should confirm that the partitions designated as RAID devices are in fact RAID devices