QA:Testcase radeon multihead

From FedoraProject

(Difference between revisions)
Jump to: navigation, search
(filename macro)
(move to the new package-specific category system)
Line 13: Line 13:
 
# gnome-display-properties should allow you to arrange the displays in any configuration, enable and disable displays, and change each display's settings; these changes should work and be reflected in what each display actually shows
 
# gnome-display-properties should allow you to arrange the displays in any configuration, enable and disable displays, and change each display's settings; these changes should work and be reflected in what each display actually shows
 
}}
 
}}
[[Category:Radeon_Test_Cases]]
+
[[Category:Package_xorg-x11-drv-ati_core_test_cases]]

Revision as of 14:21, 23 December 2010

Description

This test case tests whether multiple displays work successfully with the Radeon driver. You will need at least two monitors connected to your Radeon video adapter to perform this test.


How to test

  1. Connect as many displays as you can to the available ports on your display adapter
  2. Ensure the 'nomodeset' kernel parameter is not enabled in your bootloader configuration (unless you need it for basic X operation to succeed)
  3. Ensure the file /etc/X11/xorg.conf does not exist, or is a known-good configuration file that uses the 'radeon' driver
  4. Shut your system down entirely, then start it up again
  5. Verify that the graphical environment starts correctly and is spanned across all connected displays (Fedora 12 and later) or shows the same output on all displays (Fedora 11 and earlier)
  6. Open a console and run the command xrandr. Take a copy of the results
  7. Run the GNOME display configuration tool, gnome-display-properties. Verify that it correctly shows each of the connected displays (monitors). Test re-arranging, enabling, disabling and configuring displays

Expected Results

  1. xrandr should report each connected display and the correct available modes on each
  2. gnome-display-properties should allow you to arrange the displays in any configuration, enable and disable displays, and change each display's settings; these changes should work and be reflected in what each display actually shows