From Fedora Project Wiki

No edit summary
(template-ize)
 
(2 intermediate revisions by 2 users not shown)
Line 1: Line 1:
{{QA/Test_Case
{{Testcase_video_rendercheck|driver=radeon|module=radeon}}
|description=This test case logs the results of a basic 'rendercheck' test with the Radeon video driver, with kernel mode setting enabled. You must be using a card supported by the Radeon video driver.
[[Category:Package_xorg-x11-drv-ati_extended_test_cases]]
|actions=
# Ensure the 'nomodeset' kernel parameter is not enabled in your bootloader configuration (unless you need it for basic X operation to succeed)
# Ensure the file {{filename|/etc/X11/xorg.conf}} does not exist, or is a known-good configuration file that uses the 'radeon' driver
# Shut your system down entirely, then start it up again (using the Test Day live CD if you so choose)
# Ensure the 'rendercheck' tool is available. If you are using the Test Day live CD it will be available automatically. For other situations a package is available [http://adamwill.fedorapeople.org/nouveau/ here]
# From a console, run the following command: <pre>rendercheck -t fill,dcoords,scoords,mcoords,tscoords,tmcoords,blend,composite -f a8r8g8b8,x8r8g8b8,a8 > renderchecklog</pre>
# It will take around 15 minutes to complete (it is complete when it returns to a prompt). When it does, compress the resulting ''renderchecklog'' file (e.g. {{command|gzip renderchecklog}}) and upload it to the Wiki via the ''Upload file'' link in the left hand link bar
# Add a link to your upload in the appropriate box in the Wiki page Test Results section
|results=
# The renderchecklog file should contain a record of the complete rendercheck session
|Notes
I do a scratch build for fedora 14: [http://koji.fedoraproject.org/koji/taskinfo?taskID=2497213 here]
}}
[[Category:Radeon_Test_Cases]]

Latest revision as of 18:24, 10 January 2011

Description

This test case logs the results of a basic 'rendercheck' test on the radeon driver. You must be using a card supported by the radeon video driver.

Setup

  1. Ensure the nomodeset and radeon.modeset=0 kernel parameters are not set in your bootloader configuration
    • You can see your current kernel options by running cat /proc/cmdline
  2. Ensure the file /etc/X11/xorg.conf does not exist, or is a valid file that uses the radeon driver
  3. Shut your system down entirely, then start it up again
  4. If using a live image to test, ignore the above steps and simply boot the system from the live image with default options
  5. Ensure the rendercheck tool is available. If you are using the Test Day live CD it will be available automatically. For other situations a package is available here

How to test

  1. From a console, run the following command: rendercheck -t fill,dcoords,scoords,mcoords,tscoords,tmcoords,blend,composite -f a8r8g8b8,x8r8g8b8,a8 > renderchecklog
  2. It will take some time - from 15 minutes to several hours - to complete (it is complete when it returns to a prompt). When it does, compress the resulting renderchecklog file (e.g. gzip renderchecklog) and upload it to the Wiki via the Upload file link in the left hand link bar
  3. Add a link to your upload in the appropriate box in the Wiki page Test Results section

Expected Results

  1. The renderchecklog file should contain a record of the complete rendercheck session